Reconstitution Guide
Prep Your Tools
Use a 3ml syringe and two separate needles (25-gauge or smaller). One needle is for injecting the water, and the second is an empty needle for venting.
Sanitize
Wipe the rubber stoppers of both the peptide vial and the water vial with an alcohol prep pad. Let dry.
Draw The Water
Draw exactly 3ml of only Pfizer Hospira bacteriostatic water (do not use cheaper alternatives).
Vent The Vial
Insert the empty venting needle just through the rubber stopper to equalize pressure.
Inject Slowly
Insert the primary needle alongside the venting needle and push slowly. Aim it down the side of the glass rather than directly onto the powder.
Dissolve
Remove both needles. Gently roll the vial between your fingers and do not shake. Allow a few minutes for full dilution.
Check Clarity
The final liquid must be perfectly clear. Do not use it if it is cloudy or contains floating particles—contact us immediately.
Syringe Dosing Cheat Sheet
Using a standard U-100 insulin syringe at this 10mg/ml concentration: